The D7000 BDRA5008 is a high-power, low-noise raman fiber amplifier designed for distributed raman amplification, offering cost-effective solutions to extend the optical link power budget and significantly enhance OSNR. By using transmission fiber as the gain medium, it achieves distributed amplification, reducing system noise while optimizing gain and noise performance. Supporting from a single DWDM channel to up to 80 channels, the BDRA5008 meets the demanding requirements of service providers and enterprise networks, ensuring superior reach and optical performance.
Specifications
Product Type
Co-propagating
Noise Figure
-3~0dB (-2dB typical)
Operating Wavelength @80CH
1529~1561nm (1510nm typical)
Signal Input Power
0~20dBm
Pump Wavelength
1425~1490nm (1480nm typical)
Pump Output Power
1000mW
ON/OFF Gain
8dB
Gain Flatness
＜2.5dB (2dB typical)
Operation Mode
ACC
Connector
LC/APC
Management Interface
1x ETH RJ45
1x RS485
1x RS-232
Management
Device buttons, AmpCon™-T, WebGUI
Power Supply
85V~123VAC
170V~264VAC
170V~264VAC
Power Consumption
30W
Dimensions (HxWxD)
44x236x483mm
Weight
6kg
Relative Humidity
5%~85% (Non-condensing)
Temperature
Operating -5 to 60°C (23 to 140°F)
Storage -40 to 80℃ (-40 to 176°F)
Note:
1. RS485 and RS-232 are debug ports, not open to the public.
2. You can adjust the ON/OFF gain through the network management, the adjustment range can be from 0~8dB (co-propagating raman) but after the adjustment, it will lead to a change in the gain flatness of the whole device.
1. RS485 and RS-232 are debug ports, not open to the public.
2. You can adjust the ON/OFF gain through the network management, the adjustment range can be from 0~8dB (co-propagating raman) but after the adjustment, it will lead to a change in the gain flatness of the whole device.
